Armour Detail Supply Phobic Spray Coating 90ml

User-Friendly Ceramic Spray Coating

Armour Detail Supply Phobic Spray Coating is a user-friendly ceramic coating solution. Phobic integrates the exceptional benefits of traditional ceramic coatings into a convenient spray format, making advanced paint protection easier than ever before.

Leveraging the advanced high-solids chemistry of Armour Quartz coatings, Phobic employs next-generation silazane resins to form an exceptionally slick and hydroPhobic barrier on paintwork, trim, plastics, and glass. Despite its simple application, Phobic provides up to 2 years of durability and delivers the full spectrum of ceramic coating benefits, including superior chemical resistance. Phobic can be used as a standalone solution or as part of your existing ceramic coating maintenance regimen.

Shield your vehicle’s finish with Phobic Spray Coating, where simplicity meets exceptional performance.

CONTENTS

• 90ml Armour Phobic - Spray Coating
• 3 Spray Pumps
• 1 Orifice Reducer (alternative to spray nozzle)

DIRECTIONS

Prep:

The Prep is the most important step of the process, Armour Phobic Coating is great but it can not do the prep work for you!

1. Decontaminate the paint surface using Armour Detail Supply Decon Soap and Iron Remover, followed by removing further embedded contamination with a clay bar or clay mitt.

2. If swirl marks, or scratches are present, polish the paint to reduce any surface defects and create maximum gloss.

3. Use Armour Detail Supply Panel Prep to remove any oils/residue left from your polishing step. If you did not polish the surface, repeat this step twice to ensure a clean surface.

You are ready to apply Armour Phobic Spray Coating!

Application:

1. After thorough prep prime an applicator or short nap towel with 5 sprays to start and each subsequent application will only need 2-3 sprays, a little goes a long way.

2. Apply Phobic 1 panel at a time using overlapping circles (like a wax) making sure to have even, level coverage. Allow the product to “set up” for 30-60 seconds depending on temperature/humidity. Look for uniform small sweat beads or slight hazing to appear before removing.

3. In a similar circular motion level the coating using a plush towel for final levelling. Check for any streaks, or high spots which can appear as cloudy or dark spots. Repeat this process per panel.

4. Use a fresh side of the plush levelling towel every other panel. The application towel/pad can be used over the whole vehicle.

5. Once finished, remove spray pump from bottle and rinse thoroughly with water or alcohol solution. Secure sealing cap on bottle tightly and store in a cool/dry place for extended use.

Armour Phobic Spray Coating was designed as a single layer coating, however, it can be layered. If you wish to apply multiple layers allow 30-60 minutes between layers. This will guarantee optimal performance.

After Care:

Allow product to sit 4 hours for initial cure. After 4 hours you can apply our Armour Detail Supply Amplify or Ceramic Spray Sealant to protect the coating during its initial cure. Do not wash or induce to chemicals for 24 hours.